Publicidad
Idiomas disponibles
Idiomas disponibles
for 2 seconds.
Once the LED turns OFF, turn the ignition OFF, and the LED
2.
will start flashing.
3.
Once the LED flashes the number of times corresponding to
the digit of your PIN Number, turn the ignition ON. The
Siren will chirp 4 times, and the parking lights will flash 7
times to indicate the system is disarmed.
Pin Number Setting
Factory Preset Pin Number: 1 (Led Blinks One Time)
In disarming mode, turn ignition ON/OFF 8 times within 15 sec-
ond, and end in ON position on the eighth time. The LED will stay
solid for 2 seconds, then the system enters into PIN setting mode:
Confirm the original (preset) PIN Number
1.
Turn the ignition OFF within 10 second, LED will start blink-
ing slowly to confirm the preset PIN Number. Turn the igni-
tion ON once the LED blinks the number of times correspond-
ing to the original preset PIN number. If correct, the siren will
chirp once (if siren does not chirp, it means the preset PIN
number confirmation failed. Start the process over again if
this happens);
Input the new PIN NUMBER
2.
Right after the siren chirp once, turn the ignition Off, and the
system enters into new PIN number setting, and LED starts
to flash. When the LED flashes the number of times wanted
for the new PIN number, turn the ignition ON then OFF. The
LED will flash the new PIN number once, and then exit PIN
NUMBER setting mode.
Exit Pin Number Setting
If no operation is performed or the wrong initial Pin Number was
entered within 30 seconds, the system will exit PIN NUMBER set-
ting mode.
6
© 2019 Directed. All rights reserved.
Valet Mode
You can prevent your security system from automatically arming
by using valet mode, this is very useful when washing the vehicle,
for example. In valet mode, the security system will not arm, even
with the transmitter, but any auxiliary functions will continue to work
normally.
Enter Valet Mode
Turn the ignition ON and then OFF 2 times, and press and hold
and
within 5 seconds. The siren will chirp once, and the system
will enter valet mode. In valet mode, the LED will stay on solid for
1 hour, and then will shut off to reduce current draw. In valet mode
if you press the
button, the siren will chirp 3 times. Once the
A U X
1hour solid LED cycle ends, the LED will also flash 3 times when
the
button is pressed.
Note: Use the same method to exit valet mode.
A U X
Memory Function
This security system will store its current status to non-volatile mem-
A U X
ory. If power is lost then reconnected, the system will recall the
stored status from memory. This means if the unit is in valet mode
and the battery is disconnected for any reason, such as servicing
the vehicle, when the battery is reconnected the unit will still be
in valet mode. This applies to all statuses of the system including
disarm, and valet mode. If the system is armed and the battery is
reconnected, the system will trigger.
© 2019 Directed. All rights reserved.
A U X
7
Publicidad
