Publicidad
Idiomas disponibles
Idiomas disponibles
Each module serves as a wireless DMX transceiver, allowing each unit to act as either a transmitter or receiver. Establishing the system requires assigning
each receiver to the appropriate universe (transmitter) it intends to operate with.
ESSENTIAL NOTES BEFORE USAGE
•
Refer to the [ID] button (2) for information:
Status LED (3) WHITE: Signifies setup mode or disconnection from any transmitter.
o
TRANSMITTER MODE
o
Status LED (3) BLUE: Indicates the unit operates in TRANSMITTER mode and is linked to one or more receivers and there is a wired DMX input
o
Status LED (3) BLUE: (blinking rapidly): Demonstrates the transmitter is in the process of connecting to receiver(s).
o
Status LED (3) BLUE: (blinking slowly): Indicates absence of DMX signal on the transmitter.
o
RECEIVER MODE
o
Status LED (3) GREEN: Illustrates the unit functions in RECEIVER mode and is connected to a transmitter and there is a wired DMX output.
o
Status LED (3) GREEN: (blinking slowly): Indicates the receiver is not receiving any DMX signal from the transmitter.
o
Status LED (3) RED: (blinking rapidly): Indicates absence of a signal.
o
EASYLINK MODE
o
Status LED (3) YELLOW: Indicates the protocol Easylink in setup mode
o
Status LED (3) RED: (blinking Red): transmitting DMX Signal
o
Status LED (3) GREEN: (blinking Green): receiving DMX signal.
o
•
A receiver can only pair with a transmitter when it is fully disconnected: status LED (3) showing WHITE.
•
Hold down the [ID] button (2) while powering up the HYBRID TRANSCEIVER.
The status LED (3) will briefly turn WHITE, then change to GREEN, BLUE or YELLOW (reflecting the last selected mode).
•
Select BLUE by briefly pressing the [ID] button (2).
•
Once BLUE is selected, hold the [ID] button (2) for 3 seconds to confirm the transmitter mode.
•
The status LED will transition to white and then, after a few seconds, switch to BLUE (blinking if there is no DMX signal present).
The unit is now set in transmitter mode.
•
•
Hold the [ID] button (2) while powering up the HYBRID TRANSCEIVER. The status LED (3) will briefly turn WHITE, then change to GREEN, BLUE
or YELLOW (reflecting the last selected mode).
Select GREEN by briefly pressing the [ID] button (2).
•
•
Once GREEN is selected, hold the [ID] button (2) for 3 seconds to confirm the receiver mode.
•
The status LED will transition to white and after a few seconds switch to RED (fast blinking if there is no signal present).
•
The unit is now set in receiver mode.
To link your receiver(s) to a specific transmitter:
A.
Ensure the receivers intended for connection display a status LED (3) of WHITE, indicating they are not linked to another transmitter.
B.
Briefly press the [ID] button (2) of the transmitter; both the transmitter (BLUE) and receivers (GREEN) will start blinking on their status LEDs
(3). (If it has already been connected, a flash red indicates that the transmitter is not working)
C.
Wait until the blinking ceases: the receivers are now successfully linked to the transmitter.
D.
Verify the connection: press the [ID] button (2) on the transmitter again, and the status LEDs (3) on all linked receivers will blink. Receivers
linked to another transmitter will not blink.
Publicidad
