Sievert 443000 Manual Del Usuario página 2

Usage
• Slide the safety cover (3) up and then press the
power button (4)
• Slide the safety cover down after use.
The arc is switched off automatically after 10 seconds
of each ignition for safety reasons. Start the switch
again to reignite the arc.
Charging the Battery
The LED indicator light (7) flashes when the battery is
low. Please charge the battery immediately.
Use the USB cable to charge the battery.
Technical Data
• Connect the USB cable to a computer or any
USB port with DC 5V + -0.5V, 0.3-1A. The blue
light glows when it is charging and turns off
once the battery is fully charged. The device is
fully charged in 1-2 hours.
• Do not charge for more than 5 hours. Discon-
nect the device from the power supply after
charging.
• If the battery is low (LED indicator light is
glowing), charge the battery immediately to
extend its service life.
For charging, note the required output power of the
mains adapter / USB port:
- Output power: 5V --- / 0.3-1A
Model number
Lithium battery
Battery charging time
Micro-USB port
Recycling
Dispose of the packaging material according to
the type of material and according to any local
regulations
This appliance contains a lithium battery (220
mAh, 3.7 V, 0.81 Watt). Follow state regulations
for disposal. Owing to potentially hazardous
substances that are frequently contained in
waste electronic equipment, incorrect handling
of waste equipment may have a negative impact
on the environment and on the health of human
beings. By disposing of this appliance correctly,
you are also contributing towards an efficient
use of natural resources. Information on collec-
ting points for waste equipment can be obtained
from your local authority, the public waste
disposal authority, and authorized institution for
the disposal of waste electrical and electronic
equipment or the waste collection services.
Dispose of the packaging in an environmentally
friendly manner.
443000
220 mAh, 3.7 V, 0.81 Watt
1.5-2 hours
Max. DC 5 V ± 0.5 V, 0.3 to 1 A