Descargar Imprimir esta página

cosihome CH-D-02 Manual De Instrucciones página 9

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
Ventilation – Press this button
to activate ventilation mode.
The corresponding indicator will
illuminate. In this mode, the fan
operates without the compressor,
circulating air in the room.
Laundry - The dehumidifier
constantly operates to help dry
clothes. The fan runs at high speed
and cannot be adjusted.
Dehumidification - The appliance
works to achieve the desired
humidity level. Once the set humidity
level is reached, the dehumidifier
automatically stops.
Setting the Humidity
1.
Plug in and turn on the dehumidifier.
2.
Repeatedly press the humidity button
to select your desired humidity from
30%-80% in 5% increments.
Note: The default setting for this mode
is "30%." The compressor will stop when
the indoor humidity is 3% lower than the
set humidity, entering a standby state
while the fan runs for 2 minutes. The
compressor starts again when the indoor
humidity rises 3% higher than the set
humidity, maintaining the indoor humidity
around the set level.
Defrosting
The dehumidifier will automatically
defrost if the compressor becomes
too cold. While defrosting, the defrost
indicator light will turn on, the compressor
will turn off and the motor will keep
working.
Setting Up Continuous Drainage
1.
Remove the water tank by gently
pulling the indents on either side of
the water tank towards you.
2.
Attach one end of the continuous
drainage hose to the continuous
drainage hole.
3.
Place the other end of the hose into a
bucket or drain.
Note: Gravity will pull the water out of
the unit into your chosen drainage area.
Ensure the chosen area is not higher than
the unit.
Emptying the Water Tank
When the water tank is full, the indicator
light will turn on and the compressor will
turn off.
1.
Unplug the dehumidifier and place it
on a flat, stable surface.
2.
Remove the water tank by gently
pulling the indents on either side of
the water tank towards you.
3.
Carefully empty the water tank and
replace it by slotting it back in the
appliance.
4.
Press the power button to turn the
applaince back on.
Note: The water tank indicator light
will also turn on if the dehumidifier is
on, but the tank is missing or placed in
incorrectly.
CLEANING AND STORAGE
WARNING: ALWAYS
TURN THE APPLIANCE
OFF AND UNPLUG THE
POWER CORD FROM
THE ELECTRICAL OUTLET
BEFORE HANDLING OR
CLEANING IT.
CAUTION: DO NOT
ALLOW WATER OR OTHER
LIQUIDS TO RUN INTO
THE INTERIOR OF THE
APPLIANCE, AS THIS
COULD CREATE A FIRE
AND/OR ELECTRICAL
HAZARD.
English | 9 of 90

Publicidad

loading

Productos relacionados para cosihome CH-D-02