PROZIS SPARKY Manual Del Usuario página 7

Booster: Press the booster button to increase the brightness to 130% for one
minute. If the button is not pressed again after one minute, the light returns to its
original brightness: see page 2, figure B2
Color temperature: Press down on the adjustment dial. The color temperature will
appear on the LCD screen along with the letter H. Sliding the adjustment dial to
either side adjusts the color temperature in 1H (100K) increments. Slide and hold to
rapidly adjust the value: see page 2, figure B3
Charging: Use the USB cable included to connect the appliance to a USB port.
Alternatively, connect a USB power adapter and plug it into an available outlet. The
charging indicator will glow red while the appliance is charging. The light will be
fully charged once the indicator turns green: see page 2, figure B4
Checking the battery level: Press and hold the Booster button. The percentage
of remaining battery power will appear on the LCD screen. Once the button is
released, the screen will return to displaying brightness in five seconds: see page 2,
figure B5
Troubleshooting
Some issues that arise may be solved by the user. If the problem persists after having tried
the following solutions, please contact Prozis customer service.
PROBLEM
The device is not lightening
up.
The light went darker.
Warranty Statement
All electrical and electronic products commercialized by Prozis via www.prozis.com are cov-
ered by the warranty applicable to the purchase and sale of consumer goods.
GENERAL CONSIDERATIONS
This document contains the terms and conditions of Prozis' warranty for final consumers.
This warranty is valid exclusively for consumers who purchase the product for non-profession-
al purposes.
CAUSE
Make sure the device is switched ON. Switch ON the device.
The device has run out of battery.
The device has run out of battery.
Wrong dimming or temperature
configuration.
SOLUTION
Charge the battery.
Charge the battery.
Please check general functions for
additional information.
EN
7