Control Panel; Cleaning And Maintenance - Orbegozo PU 1000 Manual De Instrucciones

PU 1000
(2) Re-instalment：After replacing the filter mesh, keeping pressing the "timing＋wind speed" bottom for 3
seconds to reset when the device is on. Buzzer rings for once and meanwhile the state of indication flashing
light relieved, the device counts time once again.

CONTROL PANEL

1、 Switch：Touch for turning on/off.
2、 Air Speed: Touch it, air speed circularly switch from level two → level three → level one circularly.
3、 Negative Oxygen Ion: Open or close the function of Negative Oxygen Ion.
4、Timing button: Circularly press the button with the machine on or off, one can choose the timing time
circularly and switch the timing time from 1：00→2：00→4：00→ non-timing→1：00. After 2 seconds of
displaying, the countdown comes. After timing:
(1) Timed power off: with the machine on, it automatically turns off.
(2) Timed power on: with the machine off, it automatically turns on.
5、 Sleep mode: Touch to enter sleep mode.

CLEANING AND MAINTENANCE

Unplug the device each time before cleaning.
1、Cleaning the device body
1) Clean the stains using only soft cloth.
2) To clean stubborn stains that are not easily to be wiped out, use soft clot with Proper amount of neutral
detergent to clean.
Caution: Do not scratch device casing under maintenance with hard objects. When removing surface cover,
please operate in accordance with the instruction manual and do not damage device components.
Cleaning and Change of Filter Mesh
1)The change of filter mesh is reminded by built-in program. But because of different pollution extent of
actual environment, the life span of filter mesh differs. One can promptly change filter mesh according to
the voice volume or the smell produced by the device.
16