TREVIDEA Girmi BE02 Manual De Uso página 3

ENGLISH: SAFETY INSTRUCTIONS
The following are important notes on the installation, use and maintenance. Save this instruction manual for
future reference. Use the equipment only as specified in this guide. Any other use is considered improper and
dangerous. Therefore, the manufacturer cannot be held responsible in the event of damages caused by
improper, incorrect or unreasonable use. Before use, ensure the equipment is undamaged. If in doubt, do not
attempt to use it and contact the authorized service center. Do not leave packing materials (i.e. plastic bags,
polystyrene foam, nails, staples, etc.) within the reach of children as they are potential sources of danger;
always remember that they must be separately collected.
In case of failure and / or malfunction do not tamper with the unit. To repair the appliance, always contact the
service center authorized by the manufacturer and request the use of original spare parts. Failure to comply
with the above may compromise the unit safety and invalidate the warranty.
- Do not handle or touch the appliance with wet hands or bare feet. Do not expose the appliance to harmful
weather conditions such as rain, moisture, frost, etc.. Store the unit in a dry place.
- This appliance can be used by children of 8 years and above and persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they received supervision or instruction
concerning use of the appliance in a safe way and understand hazards involved; children shall not play
with the appliance; cleaning and user maintenance shall not be made by children without supervision.
- Children must not play with the appliance.
- Place it on flat and stable surface to ensure a correct operation.
- Not suitable for commercial use. Household use only
- Do not immerse in water or liquids and avoid splashing of water; clean it with a damp cloth only.
- Do not subject the product to strong impacts, serious damage may result.
- Use original spare parts and accessories only
- Before using, fully charge the product, leaving it connected to the charger for about 4 hours
Pay attention to the power supply. An incorrect voltage may damage functionality of the device. Use
only USB Type-C for charging
BE02
1. Mirror 2. LED light
OPERATING
Mount the base (5) screwing the central pin to the mirror rod.
The mirror (1) is rotating: on one side is natural without magnification, on the other it has 3x magnification.
Choose the side as needed. Press the button (3) to turn on the light (2). At the first touch you have cool light,
at subsequent touches natural and warm light, and by pressing again the light turns off.
CHARGING
When you first use the product fully charge it, leaving it connected for at least 4 hours. To recharge, connect
the USB cable to a suitable USB socket (PC, USB charger, power bank....) and into the connector on the rear
of product (5). During charging the LED (5) is red. When battery is fully charged, it becomes green.
If appliance, even after a recharge, works only if connected to the USB, it is possible that battery is no longer
capable of delivering enough power to the unit. In this case, please contact an authorized service center.
CLEANING.
Clean the unit with a damp cloth and soft and non-abrasive cleaners only.
TECHNICAL FEATURES
•
Power supply: DC 5V, USB tipo C
•
Lithium battery 1000 mAh, charge in 4 hours, working up to 5 hours
3. Button 4. USB plug for charging 5. Base
2