Dometic GROUP WAECO PocketPower TSI102 Instrucciones De Uso página 16

TSI-102.book Seite 16 Mittwoch, 17. August 2011 5:58 17
Operating the inverter
Connecting the 230 V device
➤ Insert the plug of the 230 V device into the 230 V output (fig. 1 4, page 3).
Charging the USB device
Note:
I
Always refer to the operating manual for your USB device.
➤
To charge a rechargeable device via the USB connection, plug the USB connection
of the device into the USB charger port (fig. 1 5, page 3).
7 Operating the inverter
Note
I
You can operate the inverter with the engine running or switched off. Take note
that the power supply to the 12 V socket is interrupted in some vehicles when
starting the engine.
The blue status LED (fig. 1 1, page 3) indicates that the inverter is working correctly.
If the vehicle battery voltage falls below 10.8 V or the device heats up too much during
operation, the blue LED flashes. If the voltage is too low or the device overheats, the
inverter switches itself off.
Note
I
When operating the inverter at high load for lengthy periods, it is advisable to
start the engine in order to recharge the vehicle battery.
8 Care and cleaning
Caution!
e
Before cleaning the device, pull the connecting cable out of the vehicle socket
or the cigarette lighter.
Caution!
a
Never clean the device under running water or in dish water.
Caution!
a
Do not use abrasive cleaning agents or hard objects during cleaning, as these
can damage the device.
➤
Wipe the outside with a damp cloth.
16
PocketPower TSI102
EN