Kukirin S1 Pro Manual De Usuario página 13

：
Instrumetn turn on/off Headlight open/close
Operate mode ，short
Under the close mode ：short press to turn on
press
Under the turn on operate mode:long press to
circle ：open
turn off
→ open
Have alarming notic light flashing,the value shows E1-E9 and flashing
Malfunction Code
Correspond
Please check whether the brake rear light is turn on,if not,that's the controller power is not supply powered,please replace the
receive
1E
controller and instrument.If light is on,please check whether the connection line from the instument to the controller is open.
malfunction
Motor and
2E
Check whether the motor and
controller Haul
controller wire is connect
malfunction
3E Please check whether the thumb
Thumb accelator If not,please check whether the
accelator is press down.
malfunction
accelerator is short-circuit or open-
Controller
4E Controller is damaged,replace the controller.
malfunction
under-voltage
5E Check whether the cable between the Lithium battery and controller is connect.
malfunction
Check whether the cable
If connect,Please disconnect the connecting wires to measure whether the internal resistance
between motor and between the three-phase wires of the motor is reasonable,usually within the 0.1 -1 , if
controller is connect
excess this range need to replace the motor.
6E The motor temperature is too high,Wait for the motor to cool down to operating temperature.
Motor phase
Check whether the motor
temperature is too high
The motor temperature is normal,check the cable between wire and controller is short-
circuit ,If short-circuit,replace the connect wire.
Gear change
Under the opearate mode ：double click
→second gear→
Circle:first gear
third gear →first gear turn o ffto
→
close
reserve the last gear.
Solution
If not,connect the wire between the motor and controller.
Press and release the thumb accelerator, the accelerator resets.
Open-circuit or short-circuit,replace the
connection wire
connection wire between thumb
circuit.
Replace the thumb accelerator
17 WARRANTY CARD
When purchasing products please fill in the following information completely and clearly,
and affix the seal of the seller to protect your legitimate rights and interests.
Name
User
informa
Address
tion
Contact
Product name
Product
informat
ion
Product model
Name
Seller
informa
tion
Address
Note：（1）This form should be stamped by the seller for confirmation
Three Guarantees" regulations, this guarantee card is equivalent to the "Three Guarantees Certificate"
record is subject to the maintenance certificate of the authorized service organization. After applying for service, please
keep it properly.
E-mail
Zip code
Sell date
Invoice No.
Contact
Zip code
（2)For products that are applicable to the relevant "
（3）The maintenance