Publicidad
Idiomas disponibles
Idiomas disponibles
REVERSE
OPERATION
SYSTEM
(ROS)
Your
tractor
is equipped
with
a Reverse
Operation
System
(ROS).
Any
attempt
by
the operator
to travel in the reverse
direction
with the attachment
clutch engaged
will shut
off the engine
unless
ignition
key is placed
in the ROS
"ON" position.
_WARNING"
Backing
up
with
the
attachment
clutch
engaged
while
mowing
is strongly
discouraged.
Turning
the
ROS
"ON",
to allow
reverse
operation
with the
attachment
clutch
engaged,
should
only
be done
when
the
operator
decides
it is
necessary
to reposition
the
machine
with
the
attachment
engaged.
Do not
mow
in
reverse
unless
absolutely
necessary.
USING
THE
REVERSE
OPERATION
SYSTEM
-
Only use if you are certain no children
or other
bystanders
will enter the mowing
area.
1.
Depress
brake
pedal all the way down.
2.
With
engine
running,
turn
ignition
key
counterclockwise
to ROS "ON" position.
3.
Look down
and behind
before
and while
backing.
4.
Slowly
depress
reverse
drive
pedal
to
start
movement.
5.
When use ofthe ROS is no longer needed,
turn the ignition
key clockwise
to engine
"ON" position.
ROS "ON"
POSITION
ENGINE "ON" POSITION
(NORMAL OPERATING)
TO OPERATE
ON HILLS
_I_IbWARNING:
Do not drive up or down
hills with slopes greater than 15 ° and do not
drive across any slope. Use the slope guide
provided at the back of this manual.
• Choose the slowest speed before starting
up or down hills.
• Avoid stopping or changing speed on hills.
• If stopping is absolutely necessary,
push
brake pedal quickly to brake position and
engage parking brake.
• To restart movement, slowly release park-
ing brake and brake pedal.
• Slowly depress appropriate drive pedal to
slowest setting.
• Make all turns slowly.
TOWING CARTS AND OTHER ATTACH-
MENTS
Tow only the attachments
that are recom-
mended by and comply with specifications
of the manufacturer
of your tractor.
Use
common sense when towing. Too heavy of
a load, while on a slope, is dangerous. Tires
can lose traction with the ground and cause
you to lose control of your tractor.
TO TRANSPORT
When
pushing
or towing
your tractor, be
sure to disengage
transmission
by placing
freewheel
control in freewheeling
position.
Freewheel
control
is located
at the rear
drawbar of tractor.
1. Raise attachment
lift lever to its highest
position.
2. Pull freewheel control out and intothe slot
and release so itis held in the disengaged
position.
• Do not push or tow tractor at more than
two (2) MPH.
• To re-engagetransmission,
reverse above
procedure.
TRANSMISSION
ENGAGED
TRANSMISSION
DISENGAGED
co
NOTE: To protect hood from damage when
transporting your tractor on a truck or a trailer,
be sure hood is closed and secured to tractor.
Use an appropriate means of tying hood to
tractor (rope, cord, etc.).
15
Publicidad
