Publicidad
Idiomas disponibles
Idiomas disponibles
EN
OPERATING AND MAINTENANCE MANUAL
EN 60974-7
PROCESS IDENTIFICATION
ERGOPLUS manual MIG/MAG welding torches are designed for welding low and high-alloy materials.
WARNINGS
Please read carefully the
operating and maintenance
manual before use.
Ambient conditions
Operation:
±
°C
-10°C to +40°C (+14°F to +104°F)
Transport and storage:
-25°C to +55°C (-13°F to +131°F)
Relative humidity:
Up to 90 % at 20°C (68°F)
SAFETY PRECAUTIONS
Wear gloves and other
suitable workwear in
accordance with local
regulations.
Fumes are hazardous to
health. Use fume extraction
systems or weld in
ventilated spaces only.
Protect power tools from
rain. Do not use the welding
torch on wet surfaces/
floors or in spaces with high
humidity.
All trademarks are the property of their respective owners. The information and images are indicative and may be subject to change at any time without notice. © 2022 Trafimet Group SpA
DECLARATION OF CONFORMITY
Trafimet Group Spa, a duly registered Italian Manufacturing Company, located in Via del Lavoro, 8 36020
Castegnero (VI), hereby declares that products identified and described in this manual are in conformity with
the provisions of Low Voltage Directive 2014/35 EU and in compliance with the standards set by EN 60974-7
Arc Welding Equipment - Part 7.
DECLARATION OF CONFORMITY
Trafimet Group Spa, a duly registered Italian Manufacturing Company, located in Via del Lavoro, 8 36020
Castegnero (VI), hereby declares that the products identified and described in this manual comply with the
provisions of the Electrical Equipment (Safety) Regulations 2016 and the Restriction of the Use of Certain
Hazardous Substances in Electrical and Electronic Equipment Regulations 2012.
Turn off the power source
before performing torch
maintenance. Replacement
of spare parts or other
maintenance must be
performed after the torch
has cooled down.
Dispose of this product
responsibly after use.
Torches and used parts
should be properly
recycled according to
the local requirements/
regulations.
Arc is dangerous to the
eyes. Wear a protective
helmet. Nearby people
should wear eye
protection.
Point the torch away from
yourself and others.
Torch cables must not
be squashed by heavy
objects.
Do not weld in
flammable or explosive
sites.
Do not weld on painted
surfaces.
Do not modify or make
structural changes to the
torch.
Publicidad
