cecotec READYWARM 1500 FLAMES Manual De Instrucciones página 37

1. PARTS AND COMPONENTS
Fig. 1
1. Main selector
2. On/off flame effect switch
3. Medium power switch
4. High power switch
NOTE
The graphics in this manual are schematic representations and may not exactly match the
appliance.
2. BEFORE USE
- This device is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Electric fireplace
- Instruction manual
3. OPERATION
Assembling the support base
- Simple assembly is required if the feet of your heater arrive disassembled.
- Using a screwdriver, insert three screws through the holes in each foot as shown in figure
2.
- Tighten the screws counterclockwise on the bottom of the heater.
Note: additional screws are supplied, you may have some left over after assembly.
ENGLISH
READYWARM 1500 FLAMES
37