cecotec READYWARM 2000 FLAMES Manual De Instrucciones página 38

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Adjustable temperature selector
2. Flame effect switch
3. Medium power switch
4. High power switch
NOTE:
the graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
This device is packaged in a way as to protect it during transport. Take the device out
-
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
Make sure all parts and components are included and in good conditions. If there is any
-
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
Electric fireplace
-
Instruction manual
-
3. OPERATION
Assembling the support base
Simple assembly is required if the feet of your heater arrive disassembled.
1. Using a screwdriver, insert three screws through the holes in each foot as shown in figure
2.
2. Tighten the screws counterclockwise on the bottom of the heater.
Note: additional screws are supplied, you may have some left over after assembly.
38
READYWARM 2000 FLAMES