Publicidad
Idiomas disponibles
Idiomas disponibles
3.4 – SYSTEM FITTING CHECK.
(1) Turn the vehicle ignition key on.
(2) Put the gearshift into reverse position and make sure
that the reversing light is on. Two "Beeps" of the buzzer
indicate that the system is activated.
(3) Check the detection and warning functions.
Notes:
- The sensors have the same detection range 0-30-90-
150 cm (see figure).
- All measurements are approximate. Due to an object
position, angle, size, or shape, the reflected signal may
mislead the receiving sensors. For better understanding
of measurement, please test from different approach
angles.
- To adjust sensitivity, turn the adjuster on the control unit clockwise to increase it or anticlockwire to
decrease it.
BUZZER
Off - Lo - Hi
Off-Low-High
switch
3.5 – COMPLETE THE INSTALLATION.
(1) Fix the control unit in the chosen position using supplied double-side adhesive tape or screws.
(2) Fix the buzzer in the chosen position using supplied double-sided adhesive tape.
(3) Hide all the cables as much as possible, ensuring that they are as well protected and secured as
necessary.
(4) The BUZZER volume can be selected via the switch on the buzzer.
4 – TECHNICAL DATA
-
Specified voltage
Operating voltage range
Standby current
Operating current
Working temeperature
Storage temperature
Working frequency
Operating voltage range
Working temperature
Storage temperature
Working frequency
Detection angle
Detection method
0 ~ 0,30 m
0,30 ~ 0,9 m
0,9
CONTROL UNIT
Sensitivity adjusting potentiometer
CONTROL UNIT
SENSORS
~ 1,5 m
DC12V/24V
DC9.6V ~ 30V
< 100 mA
< 200 mA
-25 °C ~80°C
-30 °C ~85°C
40KHz ± 2KHz
AC90 ~130V p-p
-25 °C ~80°C
-30 °C ~85°C
40KHz ± 2KHz
120° Horizontal
60° Vertical
Ultrasonic Wave
Continuous
beep
Beep, beep, beep
1/8 Sec.
Beep,
beep
1/2 Sec.
5
Publicidad
