Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
WARNING: Please read the instructions and
warnings for this tool carefully before use. Failure
to do so could lead to serious injury.
Explanation of symbols
Read instruction
Wear eye
before use
protectors
Prohibit to use
Warning
CO
2
or O
2
Never fire a staple into a hard-brittle surface such as concrete,
steel or tiles, unless it is designed for such application.
Keep fingers away from trigger when not operating this tool
and when moving from one operating position to another.
Keep all body parts such as hands and legs, etc. away from
firing direction and ensure staple cannot penetrate workpiece
into parts of the body.
When using the tool, be aware that the staple could deflect
and cause injury.
Only technically skilled operators should use the staple
driving tool.
Do not modify the staple driving tool. Modifications may
reduce the effectiveness of safety measures and increase the
risks to the operator and/or bystander.
Do not discard the safety instructions.
Do not use a tool if the tool has been damaged.
Be careful when handling staples, especially when loading
and unloading, as the staples have sharp points which could
cause injury.
Always check the tool before use for broken, misconnected
or worn parts.
Keep bystanders away (when working in an area where there
is a likelihood of through traffic of people). Clearly mark off
your operating area.
Only wear gloves that provide adequate feel and safe control
of triggers and any adjusting devices.
Always use the second handle (if supplied).
Don't use the tool at hard surface like steel and concrete.
When the tool is not in use, it should be placed horizontally.
Wear hearing
Wear
protectors
helmet
Fastener
Capability
being fired
of operation
in contact
actuation mode
When the tool is placed, avoid the workpiece being squeezed.
Pneumatic staple driving tools prohibit the use oxygen, and
other flammable gases.
Staple driving tools with continual contact actuation or contact
actuation shall only be used for production applications.
Professional trainers are required to operate if the following
conditions are met:
- Staples of 18gauge/1,2 mm nominal diameter or heavier
write.
- Staples with 0,8 mm nominal thickness or larger.
- Staples with 1,2 mm nominal thickness or larger.
Do not press the trigger and workpiece if your adjustment
compressed air system.
WARNING for tools with contact actuation capability
Do not rest your finger on the trigger when picking up the tool,
moving between operating areas and positions or walking, as
resting finger on trigger can lead to inadvertent operation. For
tools with selective actuation, always check the tool before
use to ascertain the correct mode is selected.
This tool has either selective actuation for contact actuation
or continuous contact actuation by actuation mode selectors
or is a contact actuation or continuous actuation contact tool
and has been marked with the symbol above. Its intended
uses are for production applications such as pallets, furniture,
manufactured housing, upholstery and sheathing.
If using this tool in selective actuation mode, always ensure it
is in the correct actuation setting.
Do not use this tool in contact actuation for applications such
as closing boxes or crates and fitting transportation safety
systems on trailers and lorries.
Be careful when changing from one driving location to
another.
Foreseeable hazards in the general use of hand-held tool
Tool user should assess the specific risks that may be present
as a result of each use.
1. PROJECTILE HAZARDS
- The staple driving tool shall be disconnected when
unloading staples, making adjustments, clearing jams or
changing accessories.
- During operation be careful that staples penetrate material
9
Publicidad
