Publicidad
Idiomas disponibles
Idiomas disponibles
AS VIEWED FROM FRONT OF MOWER
\
Hex
\
washer
head
\
screw
ASSEMBLE
WHEELS
1.
Install wheels
on threaded adjuster
axle arms.
2.
Secure each wheel with flanged
Iocknut. Tighten securely.
3. Assemble
adjustment knobs to
adjuster levers by pressing on or
tapping lightly.
Axle arm
Flanged
Iocknut
A_ustment
knob
Wheel
ASSEMBLE
ADJUSTERS
TO MOWER
DECK
Look carefully at the four (4) adjuster
assemblies.
Notice that there are two (2)
different types. Type I is for the right rear
and left front. Type II is for the right front
and left rear.
1. Place each adjuster in the middle
adjustment
position.
2.
Position appropriate
adjuster
at each
corner of mower.
3.
Install each adjuster with adjuster bolt
and tab in deck holes as shown and
secure with 1-1/4" washer (rear
adjusters only) and 3/8-16
Iocknut.
Tighten all adjusters securely.
Type I
1-1/4" Washer (Rear Adjusters Only)
Tabhole_f._
_
_-L_--_Locknuts))
)
Type I heig
(right rear/left front)
_,.J_r'_'-__
I.
Type II height adjuster _
(right front/left rear)----.,.._-_
Tab hole 7
ASSEMBLE
DISCHARGE
GUARD
1. Place discharge guard on top of lawn
mower discharge
opening.
2.
Install two (2) 1/4-20 x 3/4 hex bolts
through housing and discharge guard.
3.
Install two (2) 3/4" diameter washers
and two (2) 1/4-20 Iocknuts. Tighten
securely.
Washers
Discharge guard
Hex
Publicidad
