Svans Kiel SV30 Instrucciones De Uso página 7

EN-
Connection to the power supply
The water heater is designed for 24 volts DC only.
Voltage range: 20-29.4 volts Current connection: 400W/16A
The fuse protection of the water heater - 400Watt – 20A
Before connecting to the power supply network, be sure to fill the water tank with water !
Operation
1. To switch on the appliance, press the rotary switch; when it lights up, the appliance is in
operation.
2. Set the desired temperature on the knob on the right.
ECO: energy saving mode +/- 60°C setting the best ratio between energy consumption and
hot water yield.
3. When the set water temperature is reached on the rotary switch on the right, the control lamp
goes out, Although the switch is on. (The set water temperature has been reached).
4. As long as the main switch remains on, the boiler will maintain the set water temperature by
switching on only for a short time, visible on the indicator light, which will then light up again.
E = Energy saving mode 60°C - To prevent the growth of bacteria in the water, it is
recommended to set the water temperature to at least 60°C. This also reduces the risk of
damage to the device. This also reduces the risk of damage to the device.
Frost protection / Winter operation
-1. To prevent freezing, start the hot water cylinder and turn the setting knob to the 'frost sign'
position. The water temperature is automatically maintained at 7°C.
The power consumption is then: - 1 A/hour is suitable for a period of 1-10 days.
2. Remove or loosen the water hose on the inlet side (blue), make sure that you place a
container place a container underneath where the water can run in.
3. you can also install a water tap / valve in the inlet pipe (blue) when installing the appliance.
(blue), which then only needs to be turned on.
7