GYS PANORAMIC 3XL TRUE COLOR Guía De Notificación página 8

Translation of the original instructions
HEADBAND ADJUSTMENT
The PANORAMIC 3XL TRUE COLOR is equipped with a headband which can be adjsuted in multiple ways to suit the welder: width, height
(1), longitudinal inclination (3) and adjustment (2).
MAINTENANCE
• Expiration date : No expiration date for this product but the state of the PANORAMIC 3XL TRUE COLOR welding helmet must be
checked before each use.
• The welding helmet must not fall down.
• Do not use any tools or other sharp objects to remove any components of filter or helmet. Doing so may damage filter or helmet
preventing proper function, possibly causing injury or cancellation of the warranty.
REPLACING THE MASK BATTERY
The opto-electronic filter requires 2 3V lithium batteries (CR2045*2).
Follow the instructions below to change batteries:
- Pull the cover (11) and then remove the battery.
- Place a new battery in position. Polarity «+» must stay visible.
- Put the cover back (11).
- We recommend to replace the battery once a year.
CAUTION
- Recycle used lithium batteries. In Europe, batteries are considered as dangerous waste.
- Do not throw in the bin. To drop off only in collection point for used batteries.
REPLACING THE EXTERNAL PROTECTIVE SCREEN
1
2
The outer protection screen (2) can be removed by placing a finger
under the screen on (A) of the helmet (1).
When changing the screen, make sure that the protective film
(3) has been removed. This film must be removed only when the
3
protection screen is in position in the helmet.
A
REPLACING THE INTERNAL PROTECTIVE SCREEN (10)
A
The internal protection screen (10) is removable by sliding it down by placing a finger on (A).
10
When changing the screen, make sure you remove the protective screen (11)
WARNING
11
TROUBLESHOOTING
The optoelectronic filter does not work
Filter stays dark after the weld arc is extinguished or when no arc is
present
PANORAMIC 3XL TRUE COLOR
Warranty 2 years
Application temperature -5°C / + 55°C
Storage temperature -10°C / + 60°C
3
1
2
Activate the solar charge by exposing the cell to the light for 20 to 30
minutes
Check and clean detectors if needed.
8
EN