Publicidad
Idiomas disponibles
Idiomas disponibles
Pqr7
Weak or Dead
Fully Charged
Battery
Battery
REPLACING
BATTERY
,_
,
"
,
WARNING"
Do not short battery
terminals
by allowing
a wrench
or any
other object
to contact
both terminals
at
the same time. Before
connecting
battery,
remove
metal bracelets,
wristwatch
bands,
rings, etc.
Positive
terminal
must be connected
first to prevent
sparking
from accidental
grounding.
1. Lift seat pan to raised
position.
2.
Disconnect
BLACK
battery
cable first
then RED battery
cable and carefully
remove
battery
from tractor.
3.
Install
new battery
with terminals
in
same position
as old battery.
4.
First connect
RED battery
cable to
positive
(+) terminal
with hex bolt and
keps nut as shown.
Tighten
securely.
Slide terminal
cover over terminal
5.
Connect
BLACK
grounding
cable to
negative
(-) terminal
with remaining
hex bolt and keps nut. Tighten
securely.
Discard
Keps Nut
Terminal
-
"_
_Hex
Bolt
Protective _
Caps _
I
Terminal
Cover
Positive
(Red)
Cable
(Black)
Cable
TO REPLACE
HEADLIGHT
BULB
1.
Raise hood.
2.
Remove
bulb holder from the hole in
the backside
of the grill.
3.
Replace
bulb in holder
and install
bulb
holder securely
back into the hole in
the backside
of the grill.
4.
Close hood.
INTERLOCKS
AND
RELAYS
Loose
or damaged
wiring
may cause
your tractor
to run poorly, stop running,
or
prevent
it from starting.
• Check wiring.
See electrical
wiring
diagram
in the Repair
Parts section.
TO REPLACE
FUSE
Replace
with 30 amp automotive-type
plug-in
fuse.
The fuse holder
is located
behind
the dash.
TO REMOVE
HOOD AND
GRILL AS-
SEMBLY
1.
Raise hood.
2.
Unsnap
headlight
wire connector.
3.
Stand
in front of tractor.
Grasp
hood at
sides,
tilt toward
engine
and lift off of
tractor.
4.
When
replacing
hood, be sure to re-
connect
the headlight
wire connector.
\ --I
Hood
x
_"\
_
Headlight Wire
Connector
ENGINE
TO ADJUST
THROTTLE
CONTROL
CABLE
The throttle
control
has been preset at the
factory
and adjustment
should
not be nec-
essary.
Check
adjustment
as described
below
before
loosening
cable. If adjust-
ment is necessary,
see engine
manual.
TO ADJUST
CARBURETOR
The carburetor
has been preset
at the
factory
and adjustment
should
not be nec-
essary.
However,
minor
adjustment
may
be required
to compensate
for differences
in fuel, temperature,
altitude
or load. If the
engine
does need adjustment,
see engine
manual.
27
Publicidad
