SONOFF TECHNOLOGIES CO., LTD.
5. Add the device
Tap "+" and select "Quick Pairing", then operate following the prompt on the APP.
Compatible Pairing Mode
If you fail to enter Quick Pairing Mode (Touch), please try "Compatible Pairing Mode "
to pair.
Long press Pairing button for 5s until the Wi-Fi LED indicator changes in a cycle of
1
two short flashes and one long flash and release. Long press Pairing button for 5s
again until the Wi-Fi LED indicator flashes quickly. Then, the device enters
Compatible Pairing Mode.
Tap "+" and select " Compatible Pairing Mode " on APP.
2
Select Wi-Fi SSID with ITEAD-****** and enter the password 12345678, and then
go back to eWeLink APP and tap "Next". Be patient until pairing completes.
RF Remote Controller Pairing
The switch supports the remote controller with 433MHz frequency brand to turn
on/off, and each channel can learn it independently, which is local short-range
wireless control not Wi-Fi control.
Pairing Method:
Long press the touch button you want to pair for 3s until you hear a "beep" sound and
release, then press the corresponding button on the RF remote controller, and you
will hear a "beep" sound again after successful pairing. Other buttons can be paired
through this method.
Clearing Method:
Long press the touch button you want to clear for 5s until you hear two "beep" sounds
and release, then press the corresponding button on the RF remote controller, and you
will hear a "beep" sound again after successful clearing. Other buttons can be cleared
through this method.
Add Device
Quick Pairing
WIFI devices can be added in this mo
de(make sure the device is in pairing
mode).
Scan QR code
GSM devices and devices with QR co
de can be added in this mode.
Sound Pairing
Add device in this mode if your
devic e support this feature.
9
English