mybeo BITE HELPER Manual Del Usuario página 20

4. Initial operation
Remove the unit from the packaging and remove any packaging material. Be-
fore you can use the device, you must fully charge the battery. To do this, open
the rubber charging port cover and connect the microUSB cable to the device
and the power supply unit. During the charging process, the pink status LED of
the charging indicator flashes.
5. Operation
Press the ON/OFF button to change the mode in the following cycle: Switch on
(illuminated ring lights up) -> 40°C mode (blue status LED) -> 45°C mode (pink
status LED) -> 50°C mode (red status LED) -> Switch off.
• Switch on (illuminated ring lights up): The status LED is switched off, the
vibration is switched off, the illuminated ring is switched on. If no further
action is taken within 1 minute, the unit switches off automatically.
• 40°C mode: The vibration is switched on, the illuminated ring is switched
on, the blue status LED is activated. The status LED flashes until the 40°C
is reached. The blue status LED lights up continuously as long as the
40°C is reached. After 10 seconds of reaching 40°C, the unit automatical-
ly switches off the vibration and the illuminated ring and then switches
off. (If the 40°C is not reached within 1 minute, the unit switches off
automatically.)
• 45°C mode: The vibration is switched on, the light ring is switched on,
the pink status LED is activated. The status LED flashes until 45°C is
reached. The pink status LED light up continuously as long as the 45°C
is reached. After 10 seconds of reaching 45°C, the unit automatically
switches off the vibration and the illuminated ring and then switches
off. (If the 45°C is not reached within 1 minute, the unit switches off
automatically.)
• 50°C mode: The vibration is switched on, the illuminated ring is switched
on, the red status LED is activated. The status LED flashes until the 50°C
is reached. The red status LED lights up continuously as long as the 50°C
is reached. After 10 seconds of reaching the 50°C, the unit automatically
switches off the vibration and the illuminated ring and then switches
off. (If the 50°C is not reached within 1 minute, the unit switches off
automatically.)
20
English