Publicidad
Over-heating
Hot
protection
Detection
E10
alarm
Overload
E20
protection
Rebound
E02
protection
Overvoltage
E32
alarm
Undervoltage
E31
alarm
Step out
E60
alarm
Breaking
protection
Change Displayed
Unit (
Change
Brightness (br)
Collision Force
Detection (CF)
sales@yo-yodesk.co.uk
sales@yo-yodesk.co.uk
sales@yo-yodesk.co.uk
+ + + 44 01793 575 082
44 01793 575 082
44 01793 575 082
Protection mode (auto lock screen mode)
Alarms when continuously in motion for 5 minutes.
Power back on and wait for at least 15 minutes before adjusting height again.
Alarms when motor sensor cannot be detected.
Turn off power, check the connection of motor and control box, and then power back on.
If alarm sounds when the desk is moving up, remove loads off the desk and try again.
If it alarms when desk is moving down, turn off the power, remove loads off the desk and re-try.
Alarms when vibrated, collided or inclined during height adjustment. Check if there is anything
in the way of desk motion. Then proceed to the reset the motor.
It alarms when voltage is higher than anticipated value. Turn the power off, check the connection
between power and control box. If no problem, power it back on.
It alarms when voltage is lower than required value. Turn the power off, check the connection
between power and control box. If no problem, power it back on.
It alarms when height difference between left leg and right leg exceeds the set value.
Power off first. Check whether the left leg and the right leg are in the same height. If not, re-do
Installation Step 3 to make them same height. Power it back on.
It stops and enters protection state when motor cables or manual control cables are removed
or disconnected accidentally; goes back to normal after it's reconnected and alarm is cleared.
Engineering Mode
Long press the
button, "S--"shows and flashes. Press
S
Press
to select. Press
S
)
Press
to save your choice.
S
Long press the
button, "S--"shows and flashes. Press
S
Press
or
to switch to "br". Press
Low (L), Normal (n) or High (H) brightness. Press
Long press the
button, "S--"shows and flashes. Press
S
Press
or
to switch to "CF". Press
"OFF", Low (L), Normal (n) or Heavy (H) collision force detection.
Press
to save your choice.
S
again and the display shows "Un".
S
or
to switch between"
"(metric) or "
again and the display
S
to select. Press
or
S
to save your choice.
S
again and the display
S
to select. Press
or
S
" (imperial).
shows "Un".
to switch between
shows "Un".
to switch between
Publicidad
