Geemarc CL7160 Loop Manual De Uso página 8

INSTALLATION
(1) Connect the power supply as shown in the diagram
(2) The transmitter/charger must be connected to the audio
OUTPUT sockets of the TV, audio equipment, cable or
satellite box, DVD or VCR player, etc. When an RCA type
cable is used the outputs jacks are red and white. Refer to
the diagram.
A Scart adapter(not included) may also be used. Use only
the red and white terminals.
NOTE: If the system is connected to a cable or satellite box
and to a DVD or VCR player it is necessary to turn off the
device which is not in use at the time. When using the DVD
or VCR player turn off the cable or satellite box. When
watching TV turn off the DVD and VCR player.
(3) Connecting a microphone
If needed, connect a condenser microphone using the
microphone socket located on the rear of the Transmitter
/charger.
When connecting to a TV or other equipment which has
digital audio output terminals, use either the included Toslink
cable (optical digital) or a coaxial cable, depending on which
type of output terminals are provided on the equipment.
Please refer to the connection diagram on page 6 or to the
user manuals of your TV and other equipment.
NOTE: When using CL7160 with a digital audio input signal
the TV audio output must be set to PCM mode. CL7160 is
not compatible with Dolby Digital. The PCM setting can
normally be done using the audio menu settings of the TV.
Please refer to your TV/DVD/Satellite/Cable Box user's
manual for instructions for setting to PCM mode.
NOTE: If you wish to use the system to listen to TV while
the CL7160 is muted so as not to disturb others, the TV
audio output must be set to FIXED. Refer to the user manual
of your TV for instructions as to how to set to FIXED.
7