Publicidad
Idiomas disponibles
Idiomas disponibles
GB
LED lighting
Briefly press the LED button to switch on the LED effect lighting.
Press the LED button again briefly to change the lighting mode (party mode).
A long press on the LED button switches the LED effect lighting off.
(wireless connection of two Fontastic Lizz speakers)
TWS
Switch on both Fontastic Lizz speakers. Press and hold the start/stop button (9) of one speaker, the display
shows „t-ON" and then „BLUE". You will hear a signal tone indicating that the two speakers are
are connected to each other. One of the beige devices goes into BT mode to connect to the smartphone.
Volume control
Increase: Press and hold the Volume+ button until the desired volume is reached.
Decrease: Press and hold the Volume button until the desired volume is reached.
Technical data:
• Functions: BT/USB/ Micro-SD card reader/ FM radio/ Microphone-in/Aux-in
• Input Power: 5V DC 2.0A
• BT version: 5.3
• BT frequency: 2402MHz-2480MHz
• Output power: 60 Watt
• Speaker frequency: 20Hz-20kHz
• Speaker: 8'' woofer + 1.5'' tweeter
• Radio frequency: 87.6-107.9MHz
• Microphone input (6.3 mm)
• AUX input
• LCD display
• LED light effects with rhythm function
• TWS function
• Control via remote control
• Battery: Li-Ion battery 18650, 3600 mAh, 7.4V
• Playing time up to 3 hours
• Charging time: 4-5 hours
• Dimensions: 260 x 280 x 350mm
• Weight: 3.5 kg
Microphone
• Connection: 6.3 mm jack plug
• Cable length: 3.0 m
• On/off switch
Safety instructions:
• Never open the device
• Do not immerse the device in water and protect it from moisture.
• Never use force to connect the cable.
• Keep electrical appliances away from children.
• Disconnect electronic devices from the mains if they are not going to be used for a long period of time.
• Do not use the appliance if it is visibly damaged
No liability is accepted for any damage caused by incorrect operation.
If you require technical support, please contact our support team by e-mail at service@fontastic.eu.
7
Publicidad
