Publicidad
Idiomas disponibles
Idiomas disponibles
English
Initial Setup
Essential Setup
1. Place the unit on a flat and level surface. The selected location should be
stable and free from vibration.
2. Remove the tie-wrap that is holding the tonearm.
3. Install the turntable platter and drive belt accordingly
4. Place the slip mat on top of the turntable platter.
5. Slide Tonearm Counterweight onto the rear shaft of
tonearm and push it as close to the stop point as
possible. This will automatically set the needle's down
force to be in range for the factory fitted needle (2.5g-3.5g).
6. Use the Speaker Wire to connect the left and right speakers' Input Terminals
to the turntable's Output Terminals correspondingly. Make sure the left and
right channels are connected correctly.
7. Connect AC adaptor to the Power Jack of the unit.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is
completed. Before turning the power on, make sure again all the connection settings
are correct. Always turn off the power when connecting or disconnecting.
Turntable Platter and Belt Setup
1. Put the drive belt around the Turntable Hub, and then use the provided
drive belt assembly tool to help pull the belt to fit around the slot of motor
pulley.
2. Place the turntable platter through the turntable spindle.
5
Publicidad
