Goodwe WiFi/LAN Kit-20 Guía De Instalación Rápida página 54

Step 6 Configure the communication
parameters according to your
requirements.
Step 7 Tap save to complete the
configurations.
Quick Installation Guide V1.1-2023-09-30
Make sure that the WiFi RSSI value is higher than
-60, -50 or higher is recommended.When the RSSI
value is less than -60, you should move the router
closer to the device,remove the obstacle, or add a
repeater to improve the signal strength.
• LAN mode is only applicable to the SCD: WiFi/LAN
Kit-20.
• When both WiFi and LAN modes are enabled on
WiFi/LAN Kit-20, the communication is in LAN mode
as priority.
• If both WiFi and LAN modes are disabled on WiFi/
LAN Kit-20 simultaneously, the communication will
not be available.
Parameters
Network Name (SSID)
Encryption method
Password
DHCP
IP address
Subnet Mask
Gateway Address
DNS Server
Restore Factory Com-
munication Settings
52
Signal
Strength
NOTICE
Description
Set the parameters based on
the router network information
(only for WiFi mode).
• Enable DHCP only when
the router is in dynamic IP
mode.
• Disable DHCP when using a
switch or when the router is
in static IP mode.
• No need to configure
parameters when DHCP is
enabled.
• When DHCP is disabled,
configure parameters based
on the router or switch
information.
Used when restoring the Smart
Dongle to factory settings.