Descargar Imprimir esta página

Craftsman 358.792421 Manual Del Operador página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING
THE COUPLER
Your powerhead
is equipped with a
coupler which enables optional
attach-
ments to be installed.
The optional at-
tachments
are:
Edger ...............
358.792403
Cultivator
............
358.792410
Brushcutter
..........
358.792443
Pruner
..............
358.792450
WARNING:
Always
disconnect
powerhead
spark plug (or disconnect
powerhead
from power source) before
removing
or installing attachments.
REMOVING
ATTACHMENT
CAUTION:
When removing or instal-
ling attachments,
place tile unit on a
flat surface for stability.
1. Loosen the coupler by turning the
knob counterclockwise.
Coupler
Primary
Hole
Guide Recess
Upper
Locking/
Attachment
Shaft
Release
Button
_I, WARNING:
Make sure the lock-
ing/release
button is locked in the pri-
mary hole and the knob is securely
tightened
before operating
the unit. Us-
ing the wrong hole could lead to serious
injury or damage to the unit.
Coupler
Lower
\
Attachment
Upper Shaft
TIGHTEN
Knob
2.
Press and hold the locking/release
button.
Locking/Release
Button
/
Attachment
Upper Shaft
3. While securely
holding the upper
shaft, pull the attachment
straight
out of the coupler.
INSTALLING
ATTACHMENT
1. Remove the shaft cap from the at-
tachment
(if present) and discard.
2.
Position locking/release
button of
attachment
into guide recess of up-
per shaft coupler.
3.
Push the attachment
into the cou-
pler until the locking/release
button
snaps into the primary hole.
4.
Before using the unit, tighten the
knob securely
by turning clock-
wise.
Locking/Release
Button in Primary
Hole
INSTALLING
ATTACHMENT
HANGER
An attachment
hanger is provided for
storage
when attachment
is not in use.
To install hanger on attachment:
1.
Remove the shaft cap from the at-
tachment
(if present) and discard.
2. Press and hold the locking/release
button.
3.
Push hanger onto the attachment
until the locking/release
button
snaps into the hole.
OPERATING
POSITION
ALWAYS
WEAR:
Eye Protection
_lJ WARNING:
Inspect the area be-
fore using the unit.
Remove all debris
and hard objects such as rocks, glass,
wire, etc., that can ricochet,
be thrown,
or otherwise
cause injury or damage
during operation.
-6-

Publicidad

loading