Cleaning And Maintenance - Tristar BL-4433 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
Pulse
Use the PULSE button to blend for short times, press and keep the PULSE
button to blend, release the button to stop.
Stainless steel filter
• Proper selection of stainless steel filter direction: Filter will divide the inner
jug into 2 sections, the section inside filter makes smoothie, soup, porridge
or mixing food, the section outside filter makes Chunky food in large pores.
• For the best result we recommend to try with different amounts and
ingredient to find out what's your favorite cooking method.
• Proper Installation of filter: in the bottom, there is ring like shape
around the center blade, make sure the filter fit properly around it,
then the filter touches the bottom of jug and locked by the jug cover.
ReMaRkS
1. Add your preferred liquid or ingredients to the jug; all liquids and
ingredients used must be at room temperature.
2. Make sure the total volume of ingredients added is to the minimum
but not more than 1700ml, as the internal sensor near the base of the
jug must be covered with liquid. Under filling the soup maker jug will
result in the alarm sounding and the unit failing to operate. Should the
boiling action during cooking cause the hot contents to reach the lid,
the upper sensor will switch off the heating function to help prevent
boiling over.
3. Any interruption will result in the cancellation of the program.
Restarting will result in the cooking stages being repeated which may
affect the final recipe.
4. Any ingredients to be added during the cooking process can be added
through the refill hole in the centre of the lid. Do not unlock or remove
the lid as this will stop the program.
5. To completely stop the program at any time, simply press the START/
STOP button.
6. Once the program has finished, the soup maker will sound an audible
alarm and stop heating.
7. Your soup can be poured straight from the jug but be careful when
removing the lid from the jug as it will be very hot.
8. WARNING: heat/steam will be emitted from the lid. Care must be taken
when removing the lid and measuring cup.

cleaNINg aND MaINTeNaNce

• Always disconnect the soup maker from the mains power supply
before cleaning.
• Do not clean the soup maker in a dishwasher. Do not immerse the soup
maker in water or any liquids.
• Clean the surface of the base unit and the outer of the jug with the
supplied sponge or with a soft, damp cloth. Rinse the lid in warm,
soapy water.
• To clean the inside of the jug, rinse and use the supplied brush to
remove any remaining soup or large food particles.
• Caution: the blades inside the jug are not removable and are very
sharp; extreme caution should be taken when cleaning the inside of
the jug.
• Use the soup maker's programs to aid the removal of stubborn stains.
Assemble the soup maker and add 800ml of water and a small amount
of mild detergent. Fit the lid and switch on the soup maker. Press the
BLENDER or PULSE button and the blades will rotate to clean the jug.
You can stop the cleaning process at any time by switching off the
appliance.
Soup blender
eN
7

Publicidad

Tabla de contenido
loading

Tabla de contenido