Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2. Extend the canopy support uprights from the frame.
3. Place canopy over top of extended support uprights, ensuring the end cap is in
the cut out section of the plastic corner. Secure all four corners of the canopy.
4. Finally, ensure the textile body of the trolley is securely fixed to the steel frame.
5. Belts are tied at the corners and the textile body is wrapped around the front and
rear frames.
The hook and loop on the outside of the floor is ONLY attached to one of the sup-
port bars, which is on the underside of the car (NOT on the handlebar), as shown in
the picture.
Folding the Collapsible Wagon:
1. Remove the canopy and retract all four canopy poles. Fold up the canopy and
place in the front mesh pocket. 2. When unlocking, pull the junction plate inside the
middle of the floor upwards.
3. Push the front and rear of the frame together.
4. Please be careful that you do not pinch your fingers when folding the trolley.
Publicidad
