Publicidad
Idiomas disponibles
Idiomas disponibles
Installation - Existing Construction (continued)
5
Removing the wiring box housing
□ Remove the wiring box cover from the fan housing with
a Phillips head screwdriver (not included). Remove the
wiring knockout from the wiring box cover with a flathead
screwdriver (not included).
7
Installing the duct
□ Install a circular 4 in. duct (not included) (1) and secure it
with duct tape or clamps (neither included) (2).
□ Finish ceiling work. The ceiling hole should be aligned with
the edge of the fan housing.
6
Connecting the house and fan wires
□ Pull the wire through the hole and into the junction box (not
included). Using a quick connector, secure 120 VAC house
wiring from the wall switch to the fan as shown in the
wiring diagram. 14AWG is the smallest conductor that shall
be used for branch-circuit wiring.
CAUTION: Make sure power is switched off at service
panel before starting installation.
□ Push the wires back through the hole. Reattach the wiring
box cover.
House
wires
1
9
Quick
connector
Product
wires
2
Publicidad
