Lindy 43386 Manual De Usuario página 3

User Manual
Introduction
Thank you for purchasing the Lindy USB 2.0 Cat.6 Extender. This product has been designed to provide
trouble free, reliable operation. It benefits from both a LINDY 2 year warranty and free lifetime technical
support. To ensure correct use, please read this manual carefully and retain it for future reference.
This Lindy USB 2.0 Cat.6 Extender can be used to extend the distance between two USB peripheral
devices and the host computer by up to 50m. A standard, low cost Cat.6 network cable (not included) is
used to bridge the connection between the transmitter and the receiver unit. For best performance and
compatibility, we recommend the use of solid core patched cables.
The Extender features bidirectional Power over Cable (PoC) functionality, which provides additional
flexibility. This allows power to be supplied alongside data through Cat.6 network cable in a point-to-point
connection between the transmitter and receiver, meaning only a single power supply is required at the
transmitter or receiver unit.
Package Contents
Transmitter unit

Receiver unit

0.6m USB 2.0 A Male to B Male cable

Multi-Country Power Supply (EU, UK, US & AUS)

Lindy Manual

Specification
USB Standard: USB 2.0

Supported Bandwidth: 480Mbps

Maximum Distance: 50m (164.04ft)

Transmission Medium: Cat.5e/6 or higher network cable

Special Features: Bidirectional Power over Cable

Transmitter Input: USB Type B (Female)

Transmitter Output: RJ45 (Female)

Receiver Input: RJ45 (Female)

Receiver Output: 2 x USB Type A (Female)

Power: 3.5/1.35mm DC socket

Operating Temperature: 0° - 70°C (32°F - 158°F)

Storage Temperature: -20°C - 80°C (-4°F - 176°F)

Humidity: 0 - 90% RH (non-condensing)

Power Requirements: 5VDC 2A

Installation
1. Connect the transmitter unit to a USB port on the host computer by using the included USB 2.0 Type A
to B cable.
2. Place the receiver unit near the USB device(s) in the desired remote location.
3. Connect the included power supply either to the transmitter or receiver unit, depending on where it is
required.
4. Connect the transmitter to the receiver unit by using a Cat.5e/6 (or better) cable (not included).
5. The Extender is now correctly installed and the USB devices can be connected.
6. Power on the computer and the USB devices to complete the installation.
English