PawHut D00-192V00 Manual Del Usuario página 4

3. Folding pet carrier
Open the pet carrier cover, then press and hold the joint lock button of the upper and lower
perimeter tubes, fold the tube to the middle, and then close the pet carrier inward, and
insert the latches on both sides after closing. The pet cage can be carried in hand after
being stucked away.
rear wheel quick
break state
release button
8.Press the middle
brake lever to drive,
hook the middle
brake lever.
4.Install the pet carrier
Glue the velcro at the bottom of the pet carrier to the
frame bottom, and then buckle the back of the pet
carrier around the seat frame tube.
Reverse operation removable pet cage.
5.Usage of front wheels
Insert the front wheel into the upper seat hole of the
front wheel and hear a "click" sound. When it is time to
disassemble, press and hold the tab on the front wheel
seat and pull it down.
6.Usage of rear wheel
Install:In the break state, Align the flat form of the
wheel axle with the rear wheel locking direction
insert it in parallel until you hear a click.
When you need to disassemble, press and hold the rear
wheel quick release button and pull it out at the same
time.
7.Folding frame
In the braking state,Remove the pet cage, lift the retract
buttons on both sides up, hold the handlebars with both
hands and press down,the frame can be folded, folded
and buckled with the retracting hook.
9.For pet
harnesses.
3
10.Used for diagonal
spans.
and
11.Lift by hand.