Milomex Z30264 Manual página 16

Safety Information / Use
Safety Instructions
for Batteries
J
R emove the batteries from the device if they are
not going to be used for a prolonged period.
J
CAUTION! DANGER OF EX-
PLOSION! The batteries must never
be recharged!
J
W hen inserting the batteries, ensure the correct
polarity! This is shown in the battery compart-
ments.
J
I f necessary, clean the batteries and device
contacts before inserting the batteries.
J
R emove spent batteries immediately from the
device. There is an increased danger of leaks!
J
B atteries must not be disposed of in the normal
domestic waste!
J
E very consumer is legally obliged to dispose of
batteries in the proper manner!
J
K eep batteries away from children; do not
throw them in the fire, short-circuit them or take
them apart.
J
I f the above instructions are not complied with,
the batteries may discharge themselves beyond
their end voltage. There is then a danger of
leaking. If the batteries have leaked inside your
device, you should remove them immediately in
order to prevent damage to the device!
J
A void contact with the skin, eyes and mucous
membranes. Any parts of the body coming into
contact with battery acid should be rinsed off
with copious amounts of water and / or a doc-
tor contacted if necessary!
Use
Q
Insert Batteries / Filling of the
Q
salt and pepper mill
Indication: The salt and pepper mill is intended
for peppercorns or coarse salt.
Proceed as follows:
1. Hold the lower section with container
and turn the upper section
wise direction (see Figure A) until the arrow on
16 GB/MT
10. Hold the base with container
Q
j
j
Q
j
firmly
6
in an anticlock-
1
j
the top is aligned with the arrow on the
1
base with container
2. Now please pull the top
container .
6
3. Pull the motor carefully off the base with
3
container .
6
4. Pull the battery ring
5. Insert 4 new batteries type AA 1.5 V
Indication: Pay attention to the right polarity.
This is shown in the battery compartment.
6. Place the battery ring
.
3
7. Fill up the base with container
corns or coarse salt. The best result will be
achieved when filling the base with container
up to 75 %.
6
8. Put the motor back on the base with con-
3
tainer .
6
Indication: Please make sure that the con-
tacts , face each other (see fig. A).
4 5
9. Put the top back on the base with container
1
.
6
turn the top in a clockwise direction (see
1
fig. B) until the arrow on the upper section
is aligned with the arrow on the base with con-
tainer .
6
Using of the salt
and pepper mill
P ull off the aroma seal cover
tom of the base with container
(see fig. B).
P lease keep the button
the salt and pepper mill. The bulb
base of the salt and pepper mill will then be
simultaneously activated.
Adjusting the grinding level
T urn the adjustable screw
ceive a finer grinding level (see fig. C).
T urn the adjustable screw
.
6
off the base with
1
off the motor .
7 3
(R6).
back on to the motor
7
with pepper-
6
firmly and
6
1
from the bot-
11
before use
6
pushed to activate
2
on the
9
clockwise to re-
8
anticlockwise to
8