Publicidad
Idiomas disponibles
Idiomas disponibles
CONVERSION INSTRUCTIONS
NOTE
We will be using a 17" Tabletop Griddle in our
instructions. If you are installing this conversion on
a 22" Tabletop Griddle or a Griddle & Charcoal Grill
Combo, your install will vary slightly. We have included
2 Natural Gas Orifices for the 22" Tabletop Griddle.
STEP 1
If your griddle has been used, make sure all of the control
knobs are in the OFF position before removing the regulator
assembly from the griddle. Be sure to store LP tanks in a
safe location outside of your home.
STEP 2
Remove the griddle top from your Blackstone griddle and
set aside.
STEP 3
With a Phillips-head screwdriver and an adjustable wrench,
remove the screws that attach the burners to the griddle
body. Remove the H shaped burner tube from the griddle by
rotating it up and out of the griddle body.
Remove
Rotate up and out
STEP 4
From the rear of the griddle, using the included 7mm Orifice
Tool, remove all of the original brass orifices from the now-
accessible valves. Keep the original LP orifice with your
owner's manual.
STEP 5
Install the new NG Orifice in the valve. It will be easier
to start the NG orifice by hand and tighten with the 7mm
Orifice Tool. Be sure not to overtighten the orifice to avoid
damaging the valve body. Depending on the griddle model,
you may have a NG orifice left over. Keep it separate from
the original LP orifice with your owner's manual.
NG Orifice
It may be easier to start the new Natural Gas orifice by hand from underneath if you
have any issues trying to install it through the hole inside the griddle body.
close up of
the orifice
Publicidad
