Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND ASSEMBLY
1
Place the seat assembly (H) on the floor, face
down, with some protection so as not to scratch,
and carefully fit the base (G) in the correct
assembly position.
3
With the bowl (A) facing down and
resting on the floor on top of a guard (this
can be the packaging box itself), manually
thread the fitting reducer of the water outlet
hose with the seal (E) (which is on the
drain assembly attached to the tank (A)).
4
Fit the water outlet hose (D) to the drain reducer
(E) with the clamp (F). Hand-tighten the clamp
butterfly to secure the hose.
6
Attach the base (G) to the bowl (A) with four
hex nuts and washers (B) with an open-end
wrench 10. Make sure the grip is secure.
7
Carefully place the washbasin in an upright
position with the help of another person and fit
the electric heater bracket using the access at
the rear of the base. IMPORTANT: This support
will only be used in the specific case of item
09 of this manual.
2
Fix the 06 screws (L) by using a standard
Phillips screwdriver.
5
With the bowl (A) still resting on the floor,
manually fit the base/seat assembly (G) into
the correct assembly position.
8
Change according to the option chosen at
the time of purchase. The available kits are: 1-
Basic valve, 2- Simple Lever valve, 3- Single Lever
valve. Below are the details of the assembly and
installation of the kits:
8A
Basic Valve Assembly: To assemble the
valve and shower assembly on the bowl, remove
the fitted handle and the threaded valve finish.
After fitting the valve to the bottom of the bowl
and thread the valve finish on the top of the bowl
applying the necessary tightening, reattach the
handle manually. Thread the shower onto the
connector.
Handle
Valve
finish
Valve
Shower
Shower
connector
Publicidad
