Publicidad
Idiomas disponibles
Idiomas disponibles
iNSTALLiNG
AND REMOVING
DRULL BIT
MAKE CERTAIN the drill press is disconnected from
the power source.
Figure
14-1
NEVER run drill press to install or tighten a drill bit or
cutter in the chuck.
SUPPORTING
WORKPIECE
USE only recommended
accessories.
Figure
15-1
B
1,
Hold the chuck barrel (A) and turn the top collar (B)
clockwise to dose the chuck jaws (C), See figure
14-1.
2.
Open the chuck jaws slightly larger than the
diameter of the drill bit
3.
insert the smooth end of drill bit (D) in the chuck as
far as it will go, and then back the bit out 1/16" or
up to the beginning of the drill bit flutes (E). See
Figure 14-1.
4.
Center the drill bit in the chuck before tightening the
chuck.
Figure
14-2
o
\
A
IMPORTANT: When the workpiece (A) is long enough,
position it on the table with one end against the left side
of the column (B) to prevent the workpiece from rotat-
ing. See Figure 15-1. if it is not possible to support the
workpiece against the column, clamp the workpiece to
the table. A vise can be used to secure a small work-
piece that is too small to be clamped to the table. The
vise must be secured to the table to keep it from rotat-
ing. If you are using a backup board, it must also be
properly supported or clamped.
5,
I
F
To securely tighten the drill bit in the chuck, insert
chuck key (F) and tighten (clockwise).
See Figure
14-2.
21
Publicidad
