Gioteck TX70+ Guia De Inicio Rapido página 6

OPERATION
Power ON
Press the Power and Pair button for 1.5sec when the headset is OFF.
Power OFF
Press the Power and Pair button for 4sec when the headset is ON.
Enter pairing mode
Turn the headset OFF. Then press the Power and Pair button
for 4secs until the "pairing mode" prompt is heard.
How to connect using Bluetooth
Remove the USB Transmitter from a device if plugged in. Set the headset to pairing mode, open
Bluetooth settings on the supported device and select TX70+.
Note: The headset can connect to a single Bluetooth device at a time.
How to connect using the USB Transmitter
Enabling pairing mode on the headset will disconnect any Bluetooth devices. While the headset is
in pairing mode (check the LEDs are flashing) connect the USB transmitter to the device and the
headset will connect automatically.
If you do not hear audio immediately, check the audio output on the connected device is set to the
TX70+ headset.
Toggle between Bluetooth and the USB Transmitter
Switch between wireless modes by double-tapping the Power and Pair button.
Power save
The TX70+ headset will shuto automatically a er 5min if there is no connection.
Charging
Connect the Charge Cable to a USB Port and the headset. When the headset charges, the LEDs
on the headset will pulse. The LEDs will light solid when fully charged and blink when the battery
gets low.
05