Publicidad
Idiomas disponibles
Idiomas disponibles
Charging the panel light
1. Remove the waterproof cover and plug in the provided USB-C charging cable into the
USB-C port.
2. Connect USB-A end of the cable into a power source such as USB power adapter, power
bank or computer.
3. The panel light is fully charged when all battery indicators are lit.
4. Disconnect the USB-C cable from the panel light and re-insert the waterproof cover.
Battery indicators
Battery power capacity
0%
Charge status
0-25%
Operation
• Press the On/Off button to cycle through the 3 brightness settings: Low - Medium - High - Off
ANSI FL1 Standard
Lumens
Candela
Beam distance
Runtime
IP Rating
Impact resistance
Battery details
• Built-in 3.6V Li-Ion battery (5100mAh)
• Charging time: 5 hours
Usage and Care
• Do not dismantle the product, as this can cause harm to the product and the person will void the
warranty.
• This has a high lumen output so be careful not to shine directly into anyone's eyes as it may cause
harm and injury.
• Do not cover product when in operation to avoid excessive heat accumulation.
• The battery is sealed and cannot be replaced for your own safety.
• Do not use cleaning agents that may damage the product. Use a soft cloth to avoid scratching.
• This product uses sealed Li-ion 18650 battery. Always connect the USB carefully to avoid water
and other liquids getting into the port, which may cause damage to the unit and batteries.
• Please charge every 3 months if not used to maintain battery longevity.
• Do not leave panel light on permanently charge status as this can cause battery damage.
20%+
26-50%
51-75%
High
1200 lumens
494cd
45m
4.5h
40%+
60%+
76-99%
Medium
700 lumens
210cd
29m
7h
IPX7
1.5 m
GB
80%+
100%
Low
250 lumens
100cd
20m
17.5h
Publicidad
