Tork Matic 551103 Manual De Instrucciones página 2

AC Power Adaptor for Tork Matic Hand Towel Roll
®
Dispenser with Intuition Sensor
TM
Model: 551103
WARNING – RISK OF INJURY TO PERSONS:
When using electric appliances, basic precautions should always be followed, including
the following: a) Read all the instructions before using the appliance, b) To reduce the risk
of injury, close supervision is necessary when an appliance is used near children, c) Do not
contact moving parts, d) Use only attachments or accessories recommended or sold by the
manufacturer, e) Do not use outdoors.
The access to the service area should only be permitted to persons having knowledge and
practical experience of the appliance, in particular as far as safety and hygiene are
concerned. This appliance must only be supplied at SELV.
Use:
This dispenser is not suitable for installation outdoors or in wet environments. It is not
water-resistant. Under no circumstances should the dispenser be hosed-down or
contacted by a water jet. To ensure proper function, the dispenser must be installed in
an environment with minimum and maximum ambient temperatures between 41 and 86°F
(5 - 30°C). The dispenser should acclimate at these temperatures for 24 hours prior to
installation.
Battery and Optional Power Adaptor:
Dispenser shall be powered with three (3) D type alkaline batteries. Do not use
re-chargeable batteries. For optimal performance, batteries should be stored at
temperatures between 41 and 86°F (5 – 30°C). Do not mix batteries from different
manufacturers. Do not mix batteries with different date codes. Do not mix new and
used batteries. Three (3) batteries are to be inserted in the door of the clear battery
compartment with positive terminal facing up. When batteries have been exhausted,
they must be removed from the dispenser and safely disposed. If the dispenser is
unused or unopened for a long period of time, the batteries should be removed.
The supply terminals are not to be short-circuited. For battery installation, see
Figure 5 on page 8 of the dispenser operating instructions.
An optional manufacturer-supplied plug-in power supply is available. Order Essity part
number 551103. This accessory must be installed according to instructions provided with
the article assembly. Failure to use the manufacturer's power supply, or to follow
instructions, presents a risk of electrical shock, may result in destruction of the
dispenser and/or its software, and presents significant risk of injury or property damage.
Important - batteries must be removed prior to connecting manufacturer's power supply to
an electrical outlet.
Cleaning and Maintenance:
Exterior of dispenser should be dusted daily with a soft, lint-free cloth. Do not use abrasive
materials or paper towels as they may scratch the surface. Wipe surface as needed with a
clean, damp cloth, or a solution of mild soap and water.
The inside of the dispenser should be cleaned at least once per month, or when paper
dust is visible. Remove the paper roll. Clean dust inside the dispenser with a vacuum or
compressed air. Always wear eye protection when using compressed air. After removing
paper dust, wipe the inside of hood, roll arms, and other interior surfaces with a dry
microfiber or slightly damp cloth. Do not spray liquid or cleaners into the dispenser.
Damaged or malfunctioning product should be disposed of immediately to avoid potential
injury. Under no circumstances should the dispenser be cleaned with a water jet.
1