Levenhuk LC900 Guia Del Usuario página 4

Slope mode
The device will measure the angle of incline/decline, then calculate and display the slope-adjusted distance. In the slope mode, press
the Power/measure button (1). The angle, straight line distance value, and trajectory correction will be displayed (Fig. 3a, 3b).
Flagpole lock mode
In the slope mode, press and hold the Power/measure button (1), then move the device slightly left and right until the distance to the
flagpole is locked and displayed on the LCD (Fig. 4). After locking a flagpole, the device will vibrate.
Horizontal distance mode
In this mode, you can measure the horizontal distance to the target. The angle, straight line distance to the target, and the horizontal
distance to the target will be displayed (Fig. 5). Press the Power/measure button (1) in order to take a single measurement. Press and
hold the Power/measure button (1) for continuous measurement.
Height distance mode
In this mode, you can measure the vertical distance between two points. The angle, straight line distance to the target, and the
vertical distance between two points will be displayed (Fig. 6). Press the Power/measure button (1) in order to take a single
measurement. Press and hold the Power/measure button (1) for continuous measurement.
Figure 3a
Figure 4
Figure 5
Figure 6
4
Figure 3b