Publicidad
Idiomas disponibles
Idiomas disponibles
SYMBOLOGY
Read Operator's Manual
Double insulation
Risk of electric shock
Earth (Ground)
Danger, Warning, or Caution-
Consult the operator's manual for
additional safety information.
Battery compartment
Classification of transient overvoltages,
Cat III
based on nominal line voltage to earth.
Fuse
Do not dispose of this product as
unsorted municipal waste.
European Confirmity Mark
UL Listing for Canada and U.S.
GENERAL SPECIFICATIONS
Cat. No. ..................................................... 2217-20
Accuracy is specified for 1 year after calibration, at op-
erating temperatures of 64°F to 82°F (-18°C to 28°C),
with relative humidity at 45% to 85%, indoor use.
Maximum voltage between any
terminal and earth ground ...............600V Cat III
Temperature
Operating ...............14°F to 122°F (-10°C to 50°C)
Current Measurements ................... 14°F to 104°F
Storage ................ -40°F to 140°F (-40°C to 60°C)
Temperature Coefficient................................0.1 x
(specified accuracy)/°C (<18°C or >28°C)
Operating Altitude ...................... 6562 ft (2000 m)
IP Rating
(International Dust & Water Protection) ......... IP54
Drop Rating ....................................... 39.4 in (1 m)
Battery ..........................2 AA, ANSI 15A, IEC LR6
Battery Life .......Approx. 26 hours with all lights on
Fuse ......................... 600V AC/DC, 10A fast-acting
Safety Compliances ...........IEC/UL/CSA 61010-1,
IEC 61010-031+A1 (Probes), EN 61326-1,
FCC Part 15B, ICES-003B (EMC)
Certifications........................................ cULus, CE
(-10°C to 40°C)
IEC 61010-2-033 (Meter),
FUNCTIONAL DESCRIPTION
10
9
8
7
1. Display
2. Range button
3. °F/°C button
4. Backlight button
5. VΩ terminal input
6. COM terminal input
ASSEMBLY
To avoid an electrical hazard, turn
WARNING
the rotary dial to OFF and discon-
nect the test leads before replacing batteries.
Loading/Changing the Batteries
Replace batteries when the low
battery indicator
1. Turn rotary dial to OFF and
disconnect the test leads.
2. Unscrew and remove battery
door.
3. Insert two (2) AA batteries, ac-
cording to the polarity marked
in the battery compartment
4. Close the battery door and
tighten screw securely.
4
2
3
4
5
6
7. A mA terminal input
8. Rotary dial
9. Min/Max button
10. Hold button
11. Accessory bay
(on back, not shown)
is displayed.
1
Publicidad
