Candy CS 1410TXME/1-S Manual De Instrucciones página 58

2. INSTALLATION
Remove the 2 or 4 transportation
l
screws (A) on the back and
remove the 2 or 4 flat washers,
rubber bungs and plastic spacer
tubes (B) as illustrated in figure 1.
If the washing machine is built-in,
l
unscrew the 3 or 4 transportation
screws (A) and remove the 3 or 4
flat washers, rubber bungs and
plastic spacer tubes (B).
During the removal of the screws
l
occasionally spacer tubes fall
inside the product, these can be
remove by tilting the product forward
and recovering them from the floor or
inside the base of the machine.
Cover the open transportation screw
l
holes with the 2 or 4 plastic caps
included in the instruction bag.
WARNING:
keep packaging
away from children.
Place the corrugated plastic sheet,
l
found on top of the appliance during
the unpacking process, into the base
of the appliance as shown in figure 2
(according to the model, consider
version A, B or C).
In some models this operation
will not be necessary, because
the corrugated plastic sheet
will be already placed on the
bottom of the appliance.
materials
58
1
A
B
A
B
2
A
2
1
B
C
2
A
B
A
B
3
3
1