Publicidad
Idiomas disponibles
Idiomas disponibles
Determine which venting method is best for your application. Ductwork can extend either through the wall
or the roof.
The length of the ductwork and the number of elbows should be kept to a minimum to provide efficient
performance. The size of the ductwork should be uniform. Do not install two elbows together. Use duct tape
to seal all joints in the ductwork system. Use caulking to seal exterior wall or floor opening around the cap.
Flexible ductwork is not recommended. Flexible ductwork creates back pressure and air turbulence that
greatly reduces performance.
Make sure there is proper clearance within the wall or floor for exhaust duct before making cutouts. Do not
cut a joist or stud unless absolutely necessary. If a joist or stud must be cut, then a supporting frame must
be constructed.
There shall be adequate room ventilation when the range hood is used at the same time as appliances that
burn gas or other fuels (not applicable to appliances that merely exhaust air into the room);
WARNING!
CAUTION
WARNING!
CAUTION
VENTING REQUIREMENTS
TO REDUCE THE RISK OF FIRE, use only metal ductwork.
TO REDUCE RISK OF FIRE AND TO PROPERLY EXHAUST AIR, BE SURE
TO DUCT AIR OUTSIDE. DO NOT VENT EXHAUST AIR INTO SPACES
WITHIN WALLS OR CEILINGS OR INTO ATTICS, CRAWL SPACES, OR
GARAGES.
• DO NOT use 4" laundry-type wall caps.
• DO NOT obstruct the flow of combustion and
ventilation air.
• FAILURE TO FOLLOW VENTING REQUIREMENTS MAY
RESULT IN A FIRE.
•
there is a fire risk if cleaning is not carried out in
accordance with the instructions
•
the air must not be discharged into a flue that is used
for exhausting fumes from appliances burning gas or
other fuels
•
regulations concerning the discharge of air have to be
fulfilled
6
Publicidad
