Publicidad
Idiomas disponibles
Idiomas disponibles
ACCESSORIES
1. Disconnect power
2. Identify both ends of conduit to be fished. Ensure switch gear or other components in area of vault or box will not be damaged by tape
entering vault or box.
3. If conduit has existing wire, use flex tip on rod for pushing.
4. Insert rod into conduit.
6. Push rod through duct using short thrusts (approximately 6-8" long). This will take advantage of rod's column strength and
minimize danger of rod breakage.
NOTE: If rod loads up in canister, shake canister to loosen.
7. When rod end enters box at end of conduit and contacts vault or box wall, vibrations can normally be felt in rod.
8. Attach Pulling Eye to rod. Attach wire or cable being pulled to Pulling Eye.
9. Load rod back into canister as it is being pulled out of conduit. Use short, straight pulls to push back into canister. Do not bend,
twist or jerk rod.
10. If pull stops, check for kinking in cable or wire at entry.
1. Cut away damaged section(s) of rod with a fine-tooth hacksaw or sharp knife. Strip jacket back about 3/4" for end ferrule repair or 3/8" for
splice repair. Do not cut into or crush fiberglass core.
2. Use emery cloth to lightly roughen surface of fiberglass core end (Fig. 1).
3. Clean end of fiberglass core with solvent such as lacquer thinner or denatured alcohol. Allow it to dry completely.
4. Apply drop of adhesive to fiberglass core end (in case of a splice, do one end at a time as in Fig. 2A) and spread over core with
toothpick or nail.
5. Twist ferrule while inserting rod (Fig. 2A and 2B). Clean off excess glue. For end ferrule repair, use emery cloth to sand off excess rod
extending from end of ferrule
6. Allow sufficient time for adhesive to cure. It sets in seconds, but requires 24 hours for full cure.
2
JAMESONTOOLS.COM
Part Number
Fishing Conduit with Wee Buddy®
Splicing Rod Or Attaching New End Ferrule
|
800.346.1956
Wee Buddy Accessory Kit: Plastic Case, Flexible Leaders (2), Pulling Eye (2),
8-18-AK
Splice Ferrule (2), End Ferrule (2), Adhesive and Emery Cloth
Description
End Ferrule - Push Rod Through Conduit
Pulling Eye For Pull Line Attachment
Splice Ferrule For Rod Repair
Flexible Tips Guide Rod Around Bends,
Sweeps, Misalignments
Publicidad
