Equipment Controls; A) Control Panel Pictograms - Walter Surface Technologies SURFOX 205 Manual De Usario

2
Safety instructions
Voltage/Amperage
Before connecting this unit, check that the voltage and amper-
age shown on the rating plate is the same as the power supply.
Operating this unit other than specified on its rating plate may
result in personal injury to the user and damage the unit.
Preventive maintenance
After use, allow the cleaning accessory to cool. Remove the
cleaning pad and tungsten or the brush and the adaptor.
Neutralize with SURFOX-N and rinse with water and dry.
Clean dust and dirt deposits on the outside of the unit.
Keep air vents clean and free of any obstructions. Clean the
power cord to prevent deterioration and check for possible
damage to cord and plug.
Note: Damaged cords must be replaced immediately by
qualified personnel only. Refer to Spare Parts List for the
ordering number.
Transportation
Before transporting the machine, make sure the cleaning
solution reservoir and supply line are completely empty and
all connecting lines disconnected. The machine must be
carefully packed in a suitable container and properly
protected. WALTER will not be held responsible for any
damages resulting from leaked cleaning solution or rough
handling.
Storage
If the machine is to be stored for any length of time, the
cleaning solution reservoir and supply line must be emptied,
cleaning accessories removed, neutralized, rinsed and
dried. Store in a dry safe place to avoid damage, especially
to the electronic components.
Waste disposal
Dispose of residual waste in compliance with Federal,
Provincial, State and local environmental regulations. Refer
to WALTER Safety Data Sheet of the SURFOX electrolyte
cleaning solutions.
Extension cord
When an extension cord is needed, use wire size 14 (AWG)
for up to 50 feet (15 meters) and size 12 (AWG) for 50 to
100 feet (15 to 30 meters).
4
3

Equipment controls

Equipment controls

A) Control panel pictograms

Outlet for mini wand
or marking wand
Indicator for
internal temperature
Manual
pumping mode
INOX / STAINLESS
Application Selector
Indicator for
power output
(Marking/Mini/Large)
Indicator for LOW
solution level
Automatic
pumping mode
AC DC
Cleaning Polishing
Marking Etching
Power Selector