Publicidad
Idiomas disponibles
Idiomas disponibles
GRASS CATCHER
• The grass catcher may be hosed with
water, but must be dry when used.
• Check your grass catcher often for
damage
or deterioration.
Through
normal use it will wear. If catcher needs
replacing,
replace only with a manufac-
turer approved
replacement
catcher.
Give the lawn mower model number
when ordering.
DRIVE WHEELS
Check front drive wheels each time
before you mow to be sure they move
freely.
The wheels not turning freely means
trash, grass cuttings, etc. are in the drive
wheel area and must be cleaned to free
drive wheels.
If necessary to clean the drive wheels, be
sure to clean both front wheels.
1. Remove hubcaps, hairpin cotters and
washers.
2. Remove wheels from wheel adjusters.
3. Remove any trash or grass cuttings
from inside the dust cover, pinion and/
or drive wheel gear teeth.
4.
Put wheels back in place.
NOTE:
If after cleaning, the drive wheels
do not turn freely, contact a Sears or other
qualified
service center.
GEAR CASE
• To keep your drive system working
properly, the gear case and area
around the drive should be kept clean
and free of trash build-up.
Clean under
the drive cover twice a season.
• The gear case is filled with lubricant to
the proper level at the factory.
The only
time the lubricant needs attention is if
service has been performed on the
gear case.
• If lubricant is required,
use only Texaco
Starplex Premium 1 Grease, Part No.
750369.
Do not substitute.
ENGINE
LUBRICATION
Use only high quality detergent
oil rated
with API service classification SF-SJ.
Select the oil's SAE viscosity grade
according
to your expected
operating
temperature.
SAE VISCOSITY
GRADES
-20
0
_
32
40
e0
_10
_0
=20
-10
0
10
20
30
40
TEMPERATURE
RANGE ANTICIPATED
BEFORE
NEXT OIL CHANGE
NOTE:
Although
multi-viscosity
oils
(5W30, 10W30 etc.) improve starting in
cold weather, these multi-viscosity oils
will result in increased oil consumption
when used above 32°1=.Check your
engine oil level more frequently
to avoid
possible engine damage from running
low on oil.
Change the oil after every 25 hours of
operation or at least once a year if the
lawn mower is not used for 25 hours in
one year.
Check the crankcase
oil level before
starting the engine and after each five (5)
hours of continuous
use. Tighten oil plug
securely each time you check the oil
level.
TO CHANGEENGINEOIL
NOTE:
Before tipping lawn mower to
drain oil, drain fuel tank by running
engine until fuel tank is empty.
1. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
2. Remove engine oil cap; lay aside on a
clean surface.
3. Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to
remove any oil trapped inside of
engine.
4. Wipe off any spilled oil from lawn
mower or side of engine.
5. Fill engine with oil. (See "ADD OIL" in
the Operation section of this manual).
6. Reconnect spark plug wire to spark
plug.
Container
12
Publicidad
