SOLAX X1-EVC-7.2K Manual De Instalación página 62

Communication with Inverter
Inverter
PV array
Optional:
Inverter
connector
(white) **
If eight-core communication cable is used:
Inverter
* If the system has zero injection requirement, the EV-Charger must communicate with the inverter. For details,
please refer to https://kb.solaxpower.com/data/detail/ff80808184a409170184c63a76b20027.html.
** When communicating with the inverter, it is recommended to use a two-core cable as the communication
cable since it is more waterproof. If users use eight-core cable as the communication cable, the white inverter
connector must be used to allow the system to work normally.
Power on / Einschalten / Mettre sous tension / Encendido / Ligar / Inschakelen
/ Accensione / Zasilanie włączone / Zapnutí / Slå på / Pornirea / Включване на
захранването / Tænd / Ενεργοποίηση / Lülitage sisse / Kytke päälle / Uključite
napajanje / Bekapcsolás / Maitinimo įjungimas / Ieslēgšana / Zapnúť / Vklop / Güç
açma / Ligar a energia
• Turn on the RCBO.
• Check the status of the LED indicators, the "Complete" light should be on when the EV-
Charger starts normally. If the "Fault" light is on, please check if it is correctly installed
and connected.
58
AC Electricity
distribution meter,
CT/
box bidirectional
Meter
EV-Charger
RCBO
Home
loads
Inverter connector
(white)
Grid
Inverter side (one example)
Connect the other end of the communication
cable to the COM or RS485 port of the
inverter.
COM port of the inverter
EV-Charger