VEVOR TS181A Manual Del Usuario página 25

Target ID Cursor
bounces
The battery level indicator on the display indicates the present level of the
batteries. Four bars (
performance decrease or abnormal operation, replace the batteries
immediately when the battery level indicator becomes "
bar on the indicator ).
To replace the batteries, turn off the detector first. Then slide down the
battery cover, which is on the front of the control box ( refer to Figure 4 ), to
remove the battery cover. Replace the old batteries with new ones of the
same type, make
sure that the polarity connections are correct ( see the polarity indications
at the bottom of the battery compartment ). Reinstall the battery cover.
If Target ID Cursor bounces erratically, the detector may
have detected a junk object or the metal signal is too weak.
However, Target ID Cursor may bounce if a good target
( such as a coin ) is not parallel to the search coil or the
target is below the edge of the search coil. Target ID Cursor
may also bounce if there is one or several junk objects
existing beside the good target. Move the search coil from
different directions until Target ID Cursor becomes more
stable.
Note:
Large iron plates, depending on their orientation in the soil,
can read as a good target or cause Target ID Cursor to move
erratically.
BATTERY REPLACEMENT
) indicates that the batteries are high. To avoid
- 24 -
" ( there is no