Goalzero ALTA 80 Guia Del Usuario página 4

Getting Started
1. Plug your fridge into your Yeti Power station or vehicle's 12 V port.
2. Press the power button to turn the fridge on.
3. Press the plus and minus buttons to adjust the temperature.
NOTE: Keep the fridge out of the heat and direct sunlight for most efficient performance.
USING YOUR ALTA PORTABLE FRIDGE WITH THE GOAL ZERO APP*
1. Download the Goal Zero app from your app store.
2. Follow the instructions in the app to adjust settings.
*NOTE: Goal Zero app will be enabled for the Alta portable fridge/freezer by January 2024.
PRODUCT FEATURES
• Two independently controlled zones
• Durable high efficiency LG compressor*
• Fast cooling, 70° F to 35° F in 30 minutes
• Temperature range: -4° to 68° F, -20° to 20° C
• Eco-friendly refrigerant (R600a)
• Drain Plug
• 3-stage low voltage battery protection
• CFC free and low energy consumption
• LCD control panel for temperature setting
• Dual sided power input for optimal placement**
*LG is a registered trademark of LG and this product is not endorsed or sponsored by LG.
**NOTE: If two power sources are plugged in at the same time, the fridge will default to
the power source input closest to the control panel.
2
Settings & Functions
• Power Source: Connected with 12/24 V DC or AC 100/240 V
• Power On/Off: Press to turn the unit on/off
• Temperature Setting: Press
flashing. Then use the same buttons to adjust the temperature.
- Short Press: Adjust one degree at a time
- Long Press: Quickly adjust to desired temperature
Three seconds after the button has been released the temperature will be set.
(Note: The temperature displayed is the current temperature inside the fridge and the
number will change as the fridge adjusts to the new temperature you selected).
• Cooling Mode Control: Press to select cooling mode. Use ECO mode for
enhanced efficiency.
• Battery Protection Mode: Press
Medium, or High mode. The default setting is High. Use this mode when the fridge
is plugged into your vehicle's 12 V port. The fridge will still work when the vehicle's
engine is off. If the fridge is powered by a Yeti 200X or 500X power station, we
recommend setting it to Low protection mode. If you see the F1 error message, it
means you need to adjust the mode from High to Medium or Low.
CAUTION: This will drain your vehicle's battery and could prevent your vehicle from
starting.
• Internal Light: Press to turn on the internal light. This light will automatically turn
off after three minutes.
• Temperature Unit Selection: Press
• Zone Control: To turn off a zone, press and hold the
corresponding zone until the digits switch to "—". Repeat the process to turn the zone
back on.
until the number on the control panel begins
to cycle through settings. You can select Low,
to switch between Fahrenheit and Celsius.
and buttons of the
3