Publicidad
Idiomas disponibles
Idiomas disponibles
Switching on
3
sec.
Pilot Wire Mode
Change mode (Fig. 1)
1.
Once the batteries are installed, the LCD display shows all the symbols for 3 seconds.
After that access the Date and Time Setting interface. The date flashes and the user can
set the date using the
Then push the
key, the Hour flashes. Set the current hour using the
Then push the
key again and the minutes section flashes. Set the current minute using the
or
keys again.
Push the
to end setting the Minutes and go to Stand-by mode.
While the Date is flashing, if the user does not wish to set any parameter, that can push the
key to go directly to Stand-by mode.
2.
Having finished setting date / hour / minute and gone to Stand-by mode, push the
and the remote control will go to Comfort mode. From Comfort mode, push the
to go to Night mode. Similarly, by pushing the
change to: Comfort, Night, Anti-freeze, Clock, Pilot wire, Comfort.
Comfort and Night Mode, temperature setting (Fig. 1)
1.
Go to Night or Comfort mode. To set the temperature, use the
the
key is pushed, the temperature is increased by 0,5°C, whereas each time the
pushed, the temperature diminishes by 0,5°C. The temperature can be set between 7°C and
32°C.
2.
The temperature setting for Night mode cannot be higher than that for Comfort mode.
Example - If the temperature is set for Comfort mode at 25°C, when you enter Night mode and
try to set the temperature, on reaching 25°C even if you continue to push the
will not increase.
Date and time
setting
Stand-by Mode
Clock Mode
Anti-freeze Mode
or
keys.
[ 29 - EN ]
Comfort Mode
Night Mode
Fig. 1
or
key again, the remote control modes will
or
key, the temperature
keys.
key,
key
keys. Each time
key is
Publicidad
